1271115 RFD240DADXXA1.0/0 (G 1"/G 1 1/4") Low Pressure Filter

• Switch lever slowly over to clean filter side.

Caution when installed inline:

Before opening the filter, slowly open the vent screw and release pressure. (release pressure in the tank, if any)

• Size 60-330:

Loosen cover plate bolts and lift off the cover plate.

Sizes 660-1300:

Unscrew cover plate bolts by approx. 2 turns (no need to remove completely). Turn cover plate clockwise until it can be lifted off by holding near the bolts (bayonet fitting).

• Pull out filter element(s) (with contamination retainer, if present) by the handle. Examine element surface for dirt residues and larger particles since these can be an indication of damage to components.
• Remove contamination retainer (if present) by turning counter-clockwise – bayonet fitting.
• Replace or clean filter element(s) (only W/HC and V elements can be cleaned).
• Clean housing, cover plate and contamination retainer.
• Examine filter, especially sealing surfaces, for mechanical damage.
• Check O-rings – and replace if necessary.

Contamination or incomplete pressure release on disassembly can lead to seizing of the bowl thread.

Filter elements which cannot be cleaned must be disposed of in accordance with environmental protection regulations.

When using electrical clogging indicators, the electrical power supply to the system must be switched off before removing the clogging indicator connector.

After disassembling the filter, clean all parts, check for damage or wear and replace parts if necessary.

When changing a filter element, a high level of cleanliness must be observed.