Bosch Filter Element R928006863

Ayater filter element Introduction

Replacement filter elements for Ayater filters: Filter media for all applications made out of glassfiber-paper, filter-paper, wire mesh, non-wovens, and metal fiber.

◆ Special highly efficient filter media

◆ Adsorption of very fine particles across a broad pressure differential range

◆ High dirt holding capacity thanks to large specific filter area

◆ Good chemical resistance of the filter elements

◆ High collapse resistance of the filter elements (e.g. in case of cold start)

◆ Filter ratings: 3…100 µm

◆ As standard, each filter is equipped with mechanical-optical maintenance indicator with memory function

Bosch Rexroth filter medium Selection

Bosch filter element R928006863 Specification

Element Type: Type 2 - Zinc Free

Size: 0063

Filter Media: Glass fiber - Non-Reuseable

Micron Rating: 10

Pressure Differential: 435 psi (30 bar)

Seals: Buna-N (NBR)

Fluid Type: Mineral Oil (HLP) , Bio-Degradable, Flame Resistant

Bypass: Without Bypass Valve

Approximate Weight: 0.38 lbs

Temperature Range: Consult data sheet

Ayter filter Element exchange Methods

–  Switch off the system, the filter must be discharged on the pressure side.

–  Remove the screws at the filter cover and pull the latter upwards.

–  Remove the filter element item 4 from the lower spigot in the filter bowl by turning it slightly.

–  Check the O rings at the filter cover and at the filter bowl for damage. If necessary, they are to be renewed.

–  Replace filter elements H...XL, clean the filter element with material G ….

–  The efficiency of the cleaning process depends on the characteristics of contamination and the amount of the pressure differential before the filter element exchange. If the differential pressure after the filter element exchange exceeds 50 % of the value before the filter element exchange, the G… element also needs to be replaced.

–  Check whether the type designation or material number on the replacement element corresponds to the type designation/material number on the nameplate of the filter.

–  Install replaced or cleaned filter element on the spigot again by slightly turning it.

–  Re-assemble the filter in reverse order as described above.