A lot of people have this question is the hydraulic oil filter can be reused?
The answer is: a part of the stainless steel filter core, oil absorption filter core can be cleaned and reused, hydraulic oil filter generally can not be reused, especially fine filter, even if it is carefully cleaned, put into the hydraulic oil will also bring pollution, the proposed filter core half a year replacement. The new machine will be replaced after two months and then every six months.
The hydraulic filter core is applied in the hydraulic system, which is used to filter out the granular sundries and rubber impurities in the system to ensure the cleanliness of the hydraulic system. The features are as follows:
1. Divided into high pressure section, medium pressure section, oil recovery section and oil absorption section.
2. High, medium and low accuracy grades. 2 - 5μm is high precision, 10 - 15μm is medium precision, and 15- 25μm is low precision.
3. In order to compress the appearance size of the finished filter element, increase the filter area, the general filter layer is folded into a corrugated shape, and the pleating height of the hydraulic filter element is generally less than 20 mm.
4. The hydraulic filter element withstand pressure difference in general in 0.35-0.4 MPa, but some special filter element, the requirements to withstand high pressure difference, requirements to withstand 32MPa, or even 42MPa equivalent to the system pressure.
5. Withstand the temperature, the general requirements to reach 135℃.
